P1DF9 BMW Fault Code

Description:

Low Speed Fuel Pump Primary Circuit Malfunction The PCM monitors the low speed fuel pump (LFP) primary circuit output from the PCM.
The test fails if: When the LFP circuit is commanded on (grounded), excessive current draw is detected on the BMW LFP circuit; or when the LFP circuit is commanded off, voltage is not detected on the LFP circuit (the PCM expects to detect VPWR voltage coming through the low speed fuel pump relay coil to the LFP circuit). Open or shorted low fuel pump (LFP) circuit Open VPWR to low speed fuel pump relay Damaged low speed fuel pump relay Damaged PCM An open circuit or short to ground can only be detected with the low speed fuel pump.

P1DF9 Code Symptoms :

There are currently two main types of cylinder deactivation used today, depending on the type of engine. P1DF9 code for the pushrod design which uses solenoids to alter the oil pressure delivered to the lifters. In their collapsed state, the lifters are unable to elevate their companion pushrods under the valve rocker arms, resulting in valves that cannot be actuated and remain closed.

Diagnosis And Repairing P1DF9

P1DF9 OBD2 specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

How to fix P1DF9 code ?

• Camshaft Position Sensor harness is open or shorted
• Faulty Air Flow Meter
• Ignition misfiring
• Failures of clutch motion/travel sensors.

Gear changes are accomplished by a command from the BMW TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.